![]() Run the “STM32 Bootloader.bat” file to install the STM32CubeProgrammer DFU driver and activate the STM32 microprocessor device in USB DFU mode. ![]() To allow STM32CubeProgrammer to access the USB port through low-level commands, proceed as follows: This is achieved by typing the following command from the host PC terminal: The libusb1.0 package (including USB DFU mode) must be installed to be able to connect to the board via the USB port. For Linux host PC or Windows host PC with VMWare:.It is recommended to use the USB (in DFU mode) for flashing rather than the UART, which is too slow.īelow indications on how to install the USB in DFU mode under Linux and Windows OS, respectively. Ģ.2 Preparing the USB serial link for flashing Details about the content of this tool version are available from ST web site at Release Note.Instructions to follow for using the STM32CubeProgrammer can be found in user manual, UM2237 available from ST web site, or in STM32CubeProgrammer#How to flash with STM32CubeProgrammer article.Execute the Windows installer, which guides you through the installation process.$> ln -s /bin/STM32_Programmer_CLI /home/bin/STM32_Programmer_CLI For example, if "/home/bin" is in the PATH environment variable, run the following command: or once for all by creating a link to the STM32CubeProgrammer binary in a directory already present in PATH.either in each Terminal program in which the STM32CubeProgrammer binary needs to be used, using the following command:. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |